2.2 Before You Start
Product Completeness Check – Universal version
Check the product for completeness before installation please.
- Main board with covers – equipped with modules according to the following table:
Order No. | Extending Module (Message Recording) | Lift Blocking Module | ||
913640 |
|
| ||
913641 |
|
| ||
913642 |
|
| ||
913643 |
|
|
- Four terminal blocks (line, ALARM, CANCEL, pictograms) have been slided on the left-hand side;
- The loudspeaker and microphone (in client-designed versions, the second microphone can be connected by cable);
- CD with a full manual, Service Tools and 2N® LiftManager
- This brief manual and a warranty certificate
Product Completeness Check – Compact version
Check the product for completeness before installation please:
- Two terminal blocks (line, CANCEL) should be present on the pins at the lower case connector.
- The following fitting accessories should be enclosed:
- four M4×30 bolts
- four M4×8 bolts
- four fan-shaped washers
- four M4 nuts
- CD with a full manual, Service Tools and 2N® LiftManager
- This brief manual and a warranty certificate
ST Installation Conditions
- ST is not designed for outdoor applications.
- The product is connected to a telephone line where life-endangering voltage may occur. Therefore, be sure to keep the safety precautions – refer to the Electric Installation section.
- It is forbidden to connect ST parallel to another terminal on a line.
- The lift wall must be perfectly flat.
Tip
- Use a portable telephone to check the telephone line function.
- Do you know the telephone line number to be used? Check its functionality.
- For a PBX line connection, check other relevant conditions as included in the Ways of ST Connection section.
- Make sure that the lift panel has been prepared properly for ST mounting.
Universal version
- Check the lift panel for advance preparation for ST mounting.
Compact version
- It is advisable to mount ST where the lift cabin wall is also accessible from the outside (from the lift shaft).