5.2 Firmware Upgrade

Use the Service Tool to upgrade 2N® LiftNet. The Service Tool upgrades the CU and all audio units connected.

Procedure

  1. Connect the CU to the PC USB.
  2. Start the Service Tool.
  3. Click on  to connect the device, select the device from the list of connected devices and press OK.
  4. Select  in the toolbar.
  5. Select the FW version.
  6. Select the voice menu language version.
  7. Select whether to retain configuration, or reset the parameters to factory values.
  8. Launch the upgrading process.
  9. When the CU upgrade has been completed, you are invited to upgrade the audio units (using the Service Tool, or upgrade is executed automatically upon the system start if parameter 998 set to 1).
  10. Set date and time (Device -> Date and time setting)

Caution

  • Remember to set date and time after the upgrade.
  • Make sure that the CU and audio units have the same FW versions to avoid system errors.
  • You are recommended to factory reset the parameters to set new ranges and default values in the new FW version.

Tip

  • Back up your configuration, execute upgrade and factory default reset and upload the configuration into the device (new ranges and default values will be used in the new FW version).