2. Express Wizard for Basic Settings

LAN Connection Setting

You have to know the IP address to connect to the 2N Access Unit configuration interface successfully. Automatic IP address retrieval from the DHCP server is set by default in the 2N Access Unit. Thus, if connected to a network in which a DHCP server configured to assign IP addresses to all new devices is available, the device will obtain an IP address from the DHCP server. The 2N Access Unit IP address can be found in the DHCP server status (according to the MAC address given on the production plate), or will be communicated to you by the 2N Access Unit voice function; refer to the Installation Manual.

If there is no DHCP server in your LAN, use the 2N Access Unit RESET button to set the static IP address mode; refer to the respective Installation Manual. Your unit address will then be 192.168.1.100. Use it for the first login and then change it if necessary.

Now enter the IP address into your favourite browser. We recommend you to use the latest Chrome, Firefox or Internet Explorer (Edge) versions as 2N Access Unit is not fully compatible with earlier browser versions.

Use the name "admin" and password "2n" (i.e. default reset password) for your first login to the configuration interface. We recommend you to change the default password upon your first login; refer to the Password parameter in the Services / Web Server menu. Remember the password well or put it down. It is because if you forget the password, you will have to reset the intercom to default values (refer to the respective Installation Manual) thus losing all your current configuration changes.

Firmware Update

We also recommend you to update your firmware upon the first login to the device. Refer to www.2n.cz for the latest firmware version. Press the Update Firmware button in the System/Maintenance menu to upload firmware. The device will get restarted upon upload and only then the updating process will be complete. The process takes about 1 minute.

Electric Lock Switching Settings

An electric door lock can be attached to the 2N Access Unit and controlled by a code from the numeric keypad. Connect the electric lock as instructed in the respective Installation Manual.


Enable the switch in the Switch Enabled parameter on the Hardware / Switches / Switch 1 tab, set the Controlled Output to the intercom output to which the electric door lock is connected. Now set one or more activation codes for the electric door lock switching.